Home / News

Precautions for Shower Room Installation

Feb. 21, 2020
Share

Compared to bathtubs, contemporary young people prefer quick and convenient showers. Today, the topic that Shower Hinge Manufacturer wants to talk to everyone is about shower. Everyone should have seen the shower room. So everyone knows how to install a shower room? What do you need to know when measuring shower rooms? Let’s take a look with us. The following is the introduction of "Caution Guide for Shower Room Installation and Measurement-Related Methods".


When it comes to bathroom decoration, we must not mention the shower room, and the installation of the shower room is more expensive, so it is the key to get it all at once. The following describes the installation steps of the shower room.

1. Prepare the necessary tools.

2. Installing the basin: Combine the components of the basin, adjust the level of the basin, and ensure that there is no water accumulation in the basin and the bottom. The hose can expand and contract with distance, connecting the basin floor to the floor drain firmly.

3. Testing and protection: After installation, a water test is required to ensure that the water is unobstructed. Fourth, find the position and punch: Use a pencil and a level to determine the drilling position of the aluminum against the wall, and use an impact drill to make holes.

4. Installation of aluminum material: tap the rubber particles in the drilled holes, and lock the aluminum bars to the wall with screws.

5. Fixing the glass: Lock the Guide Glass Clamp to the hole in the bottom basin, and then fix it with screws.

6. Install the jacking pipe: find the corresponding position for drilling above the fixed glass, install (straight / slanted) fixing base and connect the jacking pipe. Fix it to the top of the glass with an elbow sleeve.

7, installation device rack: measuring position installation device rack, screw the plate nut, fix the plate glass, keep vertical and horizontal. Pay attention to waterproofing under the glass fixed aluminum.

8. Install the movable door: Install the hardware of the movable door, and install the hinge on the reserved hole of the fixed door. After installation, adjust the position of the shaft core of the lotus leaf until the door is closed.

9. Do a good job of waterproofing: Install suction bars or water-resistant rubber strips on the side or below the glass according to requirements. Close the joint between the aluminum and the wall, glass and the basin with silicone.

10. Debugging and tightening: check whether each part is comfortable and smooth to use, and adjust it in time if problems are found. After adjusting, tighten the corresponding screws to make the shower room more secure.

11. Finishing work: The decorative aluminum bar is snapped into the wall-attached aluminum material to ensure its clean appearance. The entire shower room needs to be cleaned with a rag.

Guide Glass Clamp

Guide Glass Clamp


Pay attention to the following points when installing the shower room:

1. The embedded hole size of the shower room should be designed before the bathroom is renovated.

2. Custom shower room with water supply system and tile installed.

3. Wiring leakage protection switchgear should be considered before installation in the shower room to avoid rework.

4. The style of the shower room depends on the layout of the bathroom. Common corners and flat fonts are available.

5. When installing the shower room, install it strictly according to the assembly process.

6. The shower room must be firmly connected to the building structure and must not be shaken.

7, the open shower room must use expansion bolts, fixed to the non-hollow wall, drainage, the amount of water in the bottom basin is not more than 500 grams.

8. The appearance of the shower room after installation should be neat and bright. The sliding door and sliding door should be parallel or vertical to each other.


The above are the precautions for shower room installation introduced by the supplier of Aluminum Bathroom Accessory Bathroom Knob.